#16B-1 Chuk/Changer with #26 Lathe

$754.40

Model 16B is the Chuk/Changer factory-installed to the right side of a 26A Low Base, Red Wing Lathe.This combination provides the technician with the ultimate in chuck changing efficiency at both low and high lathe speeds.The movement of the activating handle allows the technician to change from 1/4” [6.4mm] to 3/32” [2.4mm] burs, mandrels and chuck accessories without stopping the lathe.This combination will pay for itself in time saved, while providing excellent concentricity for accurate, professional results in finishing appliances. All chuck and maintenance accessories included.

115V/60Hz. Also available in 230V/50Hz, 230V/60Hz and 115V/50Hz at additional cost.

Unit Dimensions: 18 1/4” L x 8” W x 7 3/4” H [45cm x 20cm x 19cm]

Available in 1/3 HP - Model 16SB

Model 16B-1 is the 16 Chuk/Changer factory-installed on the right side of a Model 26 High Base Red Wing Lathe. The 16B-1 will allow the technician to utilize larger diameter buffs and abrasives, while obtaining the accuracy and speed of interchanging both 3/32” [2.4 mm] and 1/4” [6.4 mm] burs, mandrels and chuck accessories while the lathe is in motion. This combination will pay for itself in time saved, while providing excellent concentricity for accurate, professional results in finishing appliances. All chuck and maintenance accessories included.

115V/60Hz. Also available in 230V/50Hz, 230V/60Hz and 115V/50Hz at additional cost.

Unit Dimensions.: 18” W x 8” D x 9 1/4” H [45cm x 20.3cm x 23cm]

Available in 1/3 HP - Model 16SB-1